Brandon Jelinek

don’t do this for idex. there is no point and it will only cause you grief . The default tool board setup works for idex. don’t fix what isn’t broken.

no it does not and do not try to punch down to octopus board for idex. I spent an hour messing with this and was finally corrected on the discord channel to do exactly what the walkthrough suggests and punch the blue wire down to the tool board as instructed. rat os 2.1 rc3 clearly expects these pwms for idex to be on their own boards.

absolutely. The picture is correct but very bad that it says “crucial” but says plug black into a positive terminal. Plug black into Negative Terminal (#4 on my ssr-40 da)

piece of tape works well

Small piece of duct tape over the head of the screw and on the plate helps hold screw so it doesn’t fall out.