Editing Step 20 —
24 V Circuit - Part 5

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Black Wire(Length: 250 mm)

Insert one end on the fifth slot (numbered 5 on the board) and tighten the screw.

Insert the other end on the left slot of the [ - V ] section on the Power Supply and tighten the screw.

After tightening the screws, pull the wire to make sure it's firmly connected. If the wire releases/moves when pulling, reinsert it and tighten the screw.

Route the wire accordingly.

Your contributions are licensed under the open source Creative Commons license.