Editing Step 41 —
Y Endstop Install

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Warning: Check your cables. Incorrect endstop wiring can damage your board. If your kit isn't from the latest iteration, it may contain different endstop cables.

Connect the JST3 connector to the lowest slot available on the left.

Y Endstop Body

Y End Stop Cable ( Length: 1m )

Route the cable accordingly. Place the cables inside the extrusions to help route them.

If you are building a different V-Core 3.1 size please refer to STEP 1 for the cable length.

Your contributions are licensed under the open source Creative Commons license.