Editing Step 23 —
24 V Bed Power - Part 2

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Black Wire (Length: 200 mm)

Insert one end on the eighth slot (numbered 8 on the board) and tighten the screw.

Insert the other end on the SSR Relay negative terminal.

It's crucial that the polarity is correct, incorrect wiring will result in severe damage. Double-check your connections using the images. If you have any doubts about your SSR Relay connections please check the supplier datasheet.

After tightening the screws, pull the wire to make sure it's firmly connected. If the wire releases/moves when pulling, reinsert it and tighten the screw.

Route the wire accordingly.

Your contributions are licensed under the open source Creative Commons license.