Editing Step 25 —
Stepper Motor - Preparation

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Stepper Motor Wire

There are different lengths of cables, please read the next steps carefully.

Stepper Motor Connector (wider connector / JST PH6P)

Control Board Connector (narrower connector / JST XH2.54 )

Make sure the connectors are oriented correctly with their sockets. The "key" on the connector should align with the "gap" on the sockets.

Make sure the cables don't touch the TMC2209 heat sinks as they get hot and can damage the wires, leading to component failure.

Your contributions are licensed under the open source Creative Commons license.