Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Refer to Step 20 on how to wire a Stepper motor.

Stepper Motor Wire ( Length: 1m)

Some Extruders like the LGX Lite and the Orbiter have an embodied cable. Ignore the designated cable above.

Stepper Motor Connector (wider connector / JST PH6P)

Control Board Connector (narrower connector / JST XH2.54) - third connector counting from the bottom.

Route the cable accordingly.

If you are building a different V-Core 3.1 size please refer to STEP 1 for the cable length.

Your contributions are licensed under the open source Creative Commons license.