Editing Step 49 —
Raspberry Pi GND

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Black Jumper Wire ( Length: 250mm )

Power Input GND on the Raspberry Pi

Power Output GND on the Octopus V1.1

Route the cable accordingly.

Make sure the wires don't touch the TMC2209 heat sinks as they get hot and can damage the wires, leading to component failure.

Your contributions are licensed under the open source Creative Commons license.