Editing Step 6 —
Prepare your control board

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

BIGTREETECH Octopus V1.1

Raspberry Pi

USB A to USB C Cable

5V Power supply - smartphone charger for example (minimum 3 AMP is recommended)

It is heavily recommended that you flash your board and make sure it is detected in the configurator before you plug in your stepper drivers and start connecting your wiring. - Check RatOs documentation

Remove the highlighted jumper as it will no longer be required.

If your board flashed successfully you can proceed with the guide.

Your contributions are licensed under the open source Creative Commons license.