V-Core 3.1 Frame Assembly

Install the rear lead screw motor cage onto the frame as shown

The rear lead screw motor cage is designed so that it can only be installed in the correct position. If the part doesn't fit correctly, check the position of the 3030 T-nuts and make sure it is positioned as shown

Tighten the three M6x12 screws inside the rear lead screw motor cage to secure it to the frame. The top M6x12 screw can be accessed through the marked hole

3030 Drop-in T-Nut - M6

Place the 3030 T-nut into the extrusion channel and slide it under the lead screw motor cage as shown. Position the T-nut so that you are able to see it through the marked hole

M6x20 Cap Head Screw

Insert the M6x20 screw as shown and secure it into the previously positioned 3030 T-nut