02. Workbee
View
Options
History
1
2
3
4
5
6
7
Introduction
Details
Guide Steps
Review
Quiz
T-Nut M5. Note that the flat face is facing outwards.
Low Profile Screw M5x15mm
Recheck the bottom Eccentric Spacers on the X-Carriage-Assembly to make sure they are touching the rail, there is no wobble, and that the X-Carriage-Assembly runs smoothly along the whole length of the C-Beam.
Place the X-Gantry Assembly onto a flat table. Check if both Y-Plates are sitting flush with the table. Loosen the extrusions and adjust if needed.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.