Step Type:

Drag to rearrange

500mm 3030 Extrusion

2x Hidden Three Way Corner Assembly

Insert the hidden three way corner assembly into the 3030 extrusion fist, then place them on the previous assembly.

Measure both of the distances shown using a long ruler (preferred), or a tape measure. The measurements should be equal to each other.

If the measurements are not equal, double check all corners are square and then check again.

Go back to step 1 and build another assembly for the top of the V-Hive Enclosure.

Be careful while tightening the set screws, extreme force may break the three way hidden corner.

Your contributions are licensed under the open source Creative Commons license.