Editing Step 15 —
Front panel magnets (x5)

Step Type:

Drag to rearrange

Neodymium Disc Magnet - 10x4mm

The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet.

M6x12mm Cap Head Screw

M6 T-nut 3030 Drop in

V-Hive Enclosure Magnet Holder

Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point.

Your contributions are licensed under the open source Creative Commons license.