Editing Step 20 —
Insert the Rubber Seals

Step Type:

Drag to rearrange

Only the top, bottom and side panels need rubber seals.

Insert the rubber seals on the four sides, between the extrusion and the panel. They should fully cover the length of the extrusion slot.

Make sure all the seals are oriented with the pointy tip to the panel.

Push down with your finger until the rubber seal sits tight in the gap, ensuring a good isolation.

The rubber seals can be inserted outside or inside the V-Hive structure, depending on personal preference.

Your contributions are licensed under the open source Creative Commons license.