Step Type:

Drag to rearrange

Push the XZ Plate to the left

Tighten the first M3x16 screw on the bottom rail

Push the XZ Plate to the right

Tighten the last M3x16 screw on the bottom rail

Tighten every other M3x16 screw, starting from one end

Tighten the remaining M3x16 screws, starting from the same end as before

If the X-axis binds or becomes tight, check that the lower rail is aligned correctly. Loosening the screws securing the lower rail to the 40120 extrusion and repeat the steps above. Do not overtighten the screws as it can cause the axis to bind.

Tighten the M3x8 Cap Head Screws on the XZ Plate.

Your contributions are licensed under the open source Creative Commons license.