Step Type:

Drag to rearrange

Before continuing with the assembly, the gantry must be squared and all screws full tightened

Ensure the extrusion and the plates are pressed together with no gaps. If clamps are available, the assembly can be optionally clamped together for the remainder of this step.

Using an engineers square, or a flat edge, check that the side plates are flush with the extrusions at the top of the gantry

Fully tighten all six M12x45 screws on both ends of the gantry to secure everything together

Verify that all parts of the X-axis gantry assembly are still correctly aligned and adjust as necessary

Your contributions are licensed under the open source Creative Commons license.