Step Type:

Drag to rearrange

vc4_z_constraint

F688ZZ Ball Bearing

Insert the Bearing into the Z_constarin printed part

Make sure the bearing is inserted uniformly to avoid damaging the printed part - Use a flat surface like a wood table top to provide support to the printed part.

M6x12 Cap Head Screw

Insert an M6x12 cap head screw into each position on the lead screw constraint as shown

3030 Drop-in T-Nut - M6

Loosely thread a 3030 T-Nut onto each of the M6x12 screws. Do not tighten them at this point

Your contributions are licensed under the open source Creative Commons license.