Cable - USB-A to USB-C Cable 1500mm

Connect the USB C port on the toolboard

Connect the USB A Port on the Raspberry Pi

Red and Black Power wires

Red Wire- Power Input +24V on the Toolboard and [+V] on the Power Supply

Black Wire- Power Input GND on the Toolboard and [-V] on the Power Supply

Route the cables back to the electronics enclosure and follow the piano wire previously installed - Use some zip ties to clean the excess cable inside the electronics enclosure.

It is imperative to make sure that the USB-C connector cannot move! Tie it down to the printed part using some zip ties.