05. Compact CNC Electronics Enclosure
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
Introduction
Details
Guide Steps
Review
Quiz
Insert the stepper motor connectors in the Rodent controller:
Insert the X stepper in the top connector as shown.
Insert the Y stepper in the middle connector as shown.
Insert the Z stepper in the lower connector as shown.
The colour of the wires does not matter, as long as the coil pair is maintained.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.