Step Type:

Drag to rearrange

Ensure the lead screw surface is roughly 1-2mm inside the jog wheel

After positioning the jog wheel, tighten the two set screws to secure it in place.

Pull the X joiner plate away from the jog wheel, as to ensure the jog wheel and thrust bearing sit tight against the front Y plate.

Excessive force is unnecessary, as it may cause the lead screw to bind.

Push the lock collar against the Y front plate.

Tighten the set screw on the lock collar to secure it in place.

Install the Thrust Bearing on to the exposed end of the Lead Screw as shown

Install the Coupler - Disk Type on to the exposed end of the Lead Screw as shown

Your contributions are licensed under the open source Creative Commons license.