Ignore Y2 if you are wiring a Rat Rig Mill. Repeat the Steps to connect all drivers.

4x 550mm - Multicore 3 Conductor - 24AWG BLACK (A-(3x)Ferrule, B-(3x)Ferrule) (14)

DRIVER SIDE: Connect the white wire to PUL+ , the green wire to DIR+ and the brown wire to DIR-

AXBB-E Side: Connect the white wire to 09 , the green wire to 010 and the brown wire to the Black PTFix Block

Follow the order and connect stepper Y( PUL+ to 011, DIR+ to 012), then Z( PUL+ to 013, DIR+ to 014), Lastly Y2( PUL+ to 015, DIR+ to 016)

4x 30mm - 22AWG BLACK (A-Ferrule, B-Ferrule) (17) To jump DIR- with PUL-

4x 800mm - 16AWG RED (A-Fork, B-Ferrule) (15) The Fork terminals should be already wired to the 48V Power supplies here. Then connect it to +VDC on the driver.

4x 800mm - 16AWG BLACK (A-Fork, B-Ferrule) (16) The Fork terminals should be already wired to the 48V Power supplies here. Then connect it to GND on the driver.