Advanced ONLY

Feed all the stepper motor cables through the designated hole on the rear panel. Then insert them into the components upper panel slot, as shown.

Use 20AWG 4wire cables to connect the AXBB to the steppers, as shown in the second image. Crimp ferrules onto the ends of the wires and connect them to the A+, A-, B+, and B- terminals on the drivers. Then, attach an Xtension connector to the stepper motor end. Before cutting the cable, ensure it is sufficiently long to reach the stepper motor.

Feed all the endstop cables through the designated hole on the rear panel. Then insert them into the components upper panel slot, as shown.

Use 24AWG 3wire cables to connect the AXBB to the sendstops, as shown in the third image. Crimp ferrules onto the ends of the wires and connect them to the designated terminals on the AXBB Then, attach an Xtension to the end of the wire. Before cutting the cable, ensure it is sufficiently long to reach the endstop cable.

Feed the spindle cable through the designated hole on the rear panel. Then insert them into the components lower panel slot, as shown.

Y2 Should only be connected if you are wiring a StrongHold Machine, it's not used in the Mill.