Cables purchased from RatRig have unkeyed connectors on the end that are inserted into the controller board. What is the correct orientation for the unkeyed cable?
I found that I had to keep the belts under a small amount of tension or the belt would slip out of place so I used paper clips to hold them in place without damaging the teeth.
The Sanyo has a Yellow wire. The Datasheet calls this a sensor wire. Should this wire remain unconnected?
Cables purchased from RatRig have unkeyed connectors on the end that are inserted into the controller board. What is the correct orientation for the unkeyed cable?
I used a 1mm flat washer to provide spacing
I found that I had to keep the belts under a small amount of tension or the belt would slip out of place so I used paper clips to hold them in place without damaging the teeth.
I found that I had to remove the rigid lead screw coupler to tighten the lowest (closest to the cage) screw when installing the rear rails