Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

RatRig V-Core 3

Lid tiedown assembly

Position the lid tiedown assemblies as shown

The measurement marked should be around 120-125mm. It is not required for them to be accurate.

Tighten each M6x14 screw to secure the lid tiedown to the V-Core 3 frame.

Take care not to over tighten the M6x14 screws as you can damage the printed part.

Your contributions are licensed under the open source Creative Commons license.