Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

cable_tie printed part

M6x12 Cap Head Screw

3030 Drop In T-Nut M6

Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point.

Install the cable guide assembly as shown

Tighten the M6x12 screw to hold the cable guide in place

Take care not to over tighten the M6x12 screws as you can damage the printed parts.

Your contributions are licensed under the open source Creative Commons license.