Step Type:

Drag to rearrange

T-Plate Assembly

Follow these steps for each of the 6 T-plate assembly positions shown:

Align the T-plate assembly so that it is flush with the 3030 extrusion

Measure the gap between the T-plate assembly and the corner plate assembly

For a 200 build, the measurement should be 80mm

For 300, 400 & 500 builds, the measurement should be 130mm

Secure the T-shaped plate to the extrusion by fastening the three M6x12 screws

Double check all measurements before proceeding to the next step

Your contributions are licensed under the open source Creative Commons license.