Step Type:

Drag to rearrange

16mm Ball Screw Assembly from Step 27

Position the ball screw assembly so that:

The end with the thread faces towards the FK12 mount

The side of the ball screw block with the screw holes faces away from the frame assembly

Carefully feed the non-threaded end of the ball screw through the open hole in the idler plate

Align the threaded end of the ball screw with the hole in the FK12 mount

Whilst supporting the full length of the ball screw, insert the threaded end through the hole in the FK12 mount

The ball screw is a precision fit into the FK12 mount. Do not force the ball screw in to the mount. When correctly aligned, it should slide in with little effort

Your contributions are licensed under the open source Creative Commons license.