V-Core 4 - Full machine build
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
Introduction
Details
Guide Steps
Review
Quiz
Ensure the belt teeth are facing the stepper motor pulleys.
Ensure the belt teeth are facing the stepper motor pulleysTake one end of the lower CoreXY belt, and feed it as shown:
Feed the belt through the left stepper motor bearing stacks.
Feed the belt around the rear bearing stack on the xy_joiner.
Take the other end of the top CoreXY belt, and feed it as shown:
Feed the belt through the right stepper motor bearing stacks.
Feed the belt behind the left xy_joiner, through the front tensioner and finally the front bearing stack on the xy_joiner.
Do not cut the excess belt at this stage.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.