V-Core 4 - Full machine build
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
Introduction
Details
Guide Steps
Review
Quiz
Rat Rig toolhead fan grille printed part
Rat Rig toolhead front printed part
2x M3x35 Cap Head Screw
Feed the M3x35 cap head screws through the grille (pay close attention to its orientation), the aluminium plate and the 4028 fan, tightening them into the back printed part.
2x M3x40 Countersink Screw
The M3x40 countersink screws must go through the holes on the front assembly and thread into the duct assembly.
Take care not to over tighten the screws as you can damage the printed parts
Avoid using a ball end hex key, as they are more prone to damaging the sensitive M3 countersink screw head.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.