Editing Step 9 —
Assemble the Z plate

Step Type:

Drag to rearrange

Rat Rig Mill - Z Plate

Nut Block for TR8x4 assembly from the last step.

The M5 Nylon Locking Hex Nuts, must be facing away from the Y gantry plate.

Gently tighten the M5x16 Low Head Screws on the designated holes.

Do not overtighten the screws as it will cause binding in the lead screw. Tighten until the nut block is flush with the plate and add half a turn on the screws.

Thread the M5x16 Low Head Screws on the designated slot, Do not tighten this Nut Block, it will be adjusted later.

Your contributions are licensed under the open source Creative Commons license.