Editing Step 22 —
Install the tramming screws

Step Type:

Drag to rearrange

4x M6x8 Set screws

Look through the threaded holes; there should be no light visible on the other side. If you see light, it indicates that one of the Z plates is installed upside down. Visit this 02. Z Tower Assembly and flip the Z plate upside down.

Lightly thread the set screws into the designated holes. Once they reach the rear Z plate, stop tightening.

These screws are intended to assist the user in tramming the spindle during the commissioning process.

Your contributions are licensed under the open source Creative Commons license.