JeanPhi 35

Beware, the Rat Rig toolhead fan grille has a print mark to receive the rr_vc4_toolhead_toolboard_vertical.

Check the direction

Need to adjust the trim, they were slightly oversized

I would have prefered the change of connector being described here and not in chapter 12

go to chapter 12 before, ***Step 58*** Prepare the Rapido Hotend

and crimp the JST 2 connector, it's time saver

Thank-you for your comment. You saved my time

+1

No spare crimps.... very ANGRY....

Connector - Molex Micro-Fit - 4 Pin - Female (43020-0400) can be easily unolunt with a small srew driver.

you gain 3 crimp in step 67

Thanks for your comment ;)

Before mounting the fan go to chapter 12. Electronics ***Step 64*** Prepare the 4028 cable parts

this is far more easier now to change the fan plug than after.

I have loosen Y rails (both), realigne with center tool

then tighten lightly Y rails, then the two set of 4 screws

now you can tighten all screws