Step Type:

Drag to rearrange

V-Minion Frame Assembly

V-Minion Y-Axis Carriage Assembly from Step 7

M3x8 Cap Head Screw

Align the Y-axis carriage assembly with the Y-axis linear rail carriage and fasten securely using the four M3x8 screws

Do not over tighten the M3x8 screws as they can cause the V-Minion sub plate to twist and not be flat. This will cause issues with the print bed not being level

Slide the assembled Y-axis up and down the rail to make sure it moves smoothly

If the assembly binds at all, slightly loosen the M3x8 screws and check again

Your contributions are licensed under the open source Creative Commons license.