Step Type:

Drag to rearrange

y_endstop_mount printed part

Endstop. Install the endstop cable before fastening to the printed part

M3x8 Cap Head Screw

Secure the endstop to the mount with two M3x8 screws as shown

Take care not to over tighten the M3x8 screws as you can damage the printed part

Insert the M5x12 screw into the y_endstop_mount printed part

Loosely thread the 3030 T-Nut onto the M5x12 screw. Do not tighten it at this point

Fit the endstop assembly to the frame as shown by fastening the M5x12 screw

Your contributions are licensed under the open source Creative Commons license.