Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Refer to the side of the assembly which has the M5 holes

Remove the two M6x12 Cap Head Screws

Remove the two 3030 Drop-in T-Nut - M6

Right vc4_motor_spacer

Install the printed part next to the nema 17 stepper motors, and make sure the holes are aligned.

Insert the two M6x12 Cap Head Screws

Insert the two 3030 Drop-in T-Nut - M6

Loosely thread a 3030 T-Nut onto each of the M6x12 screws. Do not tighten them at this point.

Your contributions are licensed under the open source Creative Commons license.