Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

vc4_xy_motor_upper_right

Aluminium Spacer 3x6x30mm

Insert the Aluminium Spacer between the top and bottom plates

M3x40 Countersink Screw

Insert the M3x40 countersink screw through the top plate, the aluminium spacer 3x6x30mm, and the bottom plate. Loosely thread it onto the stepper motor. Do not tighten them at this point.

Ensure the screw head is on the same side as the countersink bore.

M5 Nylon Locking Nut

Thread the locking nut on to the M5x45 Cap Head Screw

Your contributions are licensed under the open source Creative Commons license.