Editing Step 18 —
Set-up Z Pillars (x2)

Step Type:

Drag to rearrange

Mount the linear rails on the 3060 Profiles, but only lightly fasten one screw at each extremity. You may need to adjust these later. As a reference, the distance between each linear rail and the profile edge should be 9mm on either side.

CAUTION: align the extremity of the Linear Rails with the top side of the profiles, not the bottom side (top and bottom as seen on the picture).

3060 T-Slot 400mm

MGN12 Linear Rail 400mm

Corner Connector 3030

Corner Connector 2030 (side with no tabs facing up)

This length should be 30mm

Your contributions are licensed under the open source Creative Commons license.