01. Rat Rig V-Cast
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
Introduction
Details
Guide Steps
Review
Quiz
Cast corner screws: fasten them slightly, leaving them loose enough that they can slide through the profile if needed.
Lightly fasten one screw at both ends of each linear rail. Leave the others loose for now. As a reference, the distance between each linear rail and the profile edge should be 9mm on either side.
3030 T-Slot 480mm
MGN12 Linear Rail 500mm + 1x MGN12C
MGN12 Linear Rail 500mm + 2x MGN12C
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.