Editing Step 29 —
Mount Bed Plate

Step Type:

Drag to rearrange

THIS SIDE UP: on the top side of the bedplate you can see 4 counterbore holes to make room for screw heads. On the bottom side, you will only see 4 small holes.

Glue your heat pad to the BOTTOM SIDE of the bed plate. Be careful not to place the pad over any of the bedplate holes.

Heat pad

Bedplate

Low profile M5x25mm

Spring

Hex Locking Nut M5. Tighten or loosen these to level your bed.

Your contributions are licensed under the open source Creative Commons license.