Editing Step 22 —
Assemble Z Pillars

Step Type:

Drag to rearrange

Assemble the Z pillars by tightening the vertical screws on the Corner Connectors first. Don't tighten too hard for now, you may need to adjust.

216mm

204mm

Joining Plates (x4). Use these plates to help you square the Z Pillars. Once you're sure your assembly is square, tightly fasten all screws both on the Joining Plates and on the Cast Corners.

Add the Z motors to the structure and firmly tighten the screws.

CAUTION: look carefully at the image to understand which motor mount should go left and which should go right. The positioning is NOT reversible.

Your contributions are licensed under the open source Creative Commons license.