Editing Step 24 —
Assemble the VAOC - Part 8

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

If your machine is enclosed, ensure that you route the wire through the rear electronics panel before connecting it to the camera. The USB connector will not fit through the panel hole, so the camera's PCB connector must be fed through before assembly.

vc4_vaoc_vent

Align the small tabs on the printed parts to ensure the correct assembly orientation.

Ensure the cable exit is on the same side as the VAOC LEDs module connector.

Camera DSP PCB

Connect the 5cm FPC to the Camera DSP PCB

Connect the camera cable to the module before installation. Once the PCB is in place, the VC4_VAOC_midframe will secure the connector, making it impossible to disconnect.

Ensure the Camera DSP PCB is correctly aligned in the vc4_VAOC_vent and fully seated.

Your contributions are licensed under the open source Creative Commons license.