Editing Step 10 —
Install the spool holder arm

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

The spool holder can be mounted on either side of the machine, this guide will instruct you to install it on the left side of the machine for single-head configuration.

2x M6x12 Cap Head Screw

2x M6 Washer

Remove the shown M6x12 screws and their corresponding washers in order to allow for the spool holder arm to be installed.

Avoid moving the machine around or bumping into it, to prevent the t-nuts from moving.

The second spool holder is assembled! almost ready to print

Your contributions are licensed under the open source Creative Commons license.