Step Type:

Drag to rearrange

panel_magnet_mount printed part

Neodymium Disc Magnet - 10x4mm

The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet

M6x12 Cap Head Screw

3030 Drop-in T-Nut - M6

Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point.

Set these assemblies aside until Steps 82 & 84

Your contributions are licensed under the open source Creative Commons license.