Editing Step 11 —
Assemble the top panel

Step Type:

Drag to rearrange

panel_enc2_top_size

Install four of the panel magnet mount assemblies to the top panel

Take care not to over tighten the M6x12 screw as you can damage the printed parts

Install two of the Rat Rig nylon handles to the top panel

Do not overly tighten the M6 nylon locking hex nuts when securing the handles, as this can cause the panel to warp which will prevent a good seal to the printer

Set the completed top assembly aside until Step 83

Your contributions are licensed under the open source Creative Commons license.