Step Type:

Drag to rearrange

panel_magnet_holder printed part

Neodymium Disc Magnet - 10x4mm

Pay attention to the orientation of the magnets when installing them into the printed parts. Use the assemblies from the previous step to verify the magnets attract to each other, rather than repell from each other!

The magnets are designed to be a tight fit into the printed part. If they are loose, or you wish to secure them further, place a few drops of cyanoacrylate glue into the printed part before adding the magnet

M6 Nylon Locking Hex Nut

Set these assemblies aside until Steps 7, 8 & 11

Your contributions are licensed under the open source Creative Commons license.