Step Type:

Drag to rearrange

M6x12 Cap Head Screw

Loosen all of the M6x12 screws and remove both corner plate assemblies

Loosen but do not remove the marked M6x12 screws

Pull the rear left 3030 extrusion upwards to remove it from the machine frame

Insert the 760mm 3030 extrusion into the bottom corner plate assemblies

You may need to rotate the 3030 t-nuts to insert the 3030 extrusion

Measure from the underside of the rear extrusion, to the top of the newly installed extrusion. It should measure either 230mm (for a V-Core 3 200) or 280mm (for a V-Core 300, 400 or 500)

Tighten the six marked M6x12 screws to secure the 3030 extrusion to the frame

Your contributions are licensed under the open source Creative Commons license.