Step Type:

Drag to rearrange

Rear base plate assembly

Carefully place it inside the frame. The Z cable passthrough should be on the left side when facing the front of the printer.

Ensure the base plate assembly is pushed all the way to the back and aligned with the rear extrusions.

When sliding the base plate assembly to the right place, be careful, and take it slowly so as to not damage the extrusion coating.

Place the base plate assembly on the bottom of the frame

Make sure every 3030 Drop In T-nut aligns with the extrusion slots

Tighten the M6x12 Cap Head Screws to secure the base plate assembly to the frame.

Your contributions are licensed under the open source Creative Commons license.