V-Core 4 - Full machine build
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
Introduction
Details
Guide Steps
Review
Quiz
In this step, you will prepare two stepper motor plates with screws and T-nuts, although they will only be used to align the frame.
Rat Rig V-Core 4.0 - Motor Plate - Lower Left v1.0
Rat Rig V-Core 4.0 - Motor Plate - Lower Right v1.0
8x M6x12 Cap Head Screw
8x 3030 Drop In T-Nut M6
Loosely thread the 3030 T-Nuts onto the M6x12 screws. Do not tighten them at this point.
Please notice: The t-nuts should be on the same side as the countersink holes.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.