Editing Step 24 —
Assemble the rear panel

Step Type:

Drag to rearrange

Panel Assembly - Rear

M6x12 Cap Head Screw

M6 Washer

T-Nut Drop In for 3030 - M6

Insert a M6x12 Screw into a M6 washer through the rear panel, and loosely tighten a T-Nut.

Double check the panel orientation, an easy way to make sure is to orient the panel in a position where the marked hole is more to the left than to the right.

Insert a vc4_grommet_V1 in each designated hole from the same side as the t-nuts

Your contributions are licensed under the open source Creative Commons license.