Step Type:

Drag to rearrange

Stepper Motor Wire

Front Z Steppers cables 1500mm

Rear Z Stepper cable 1000mm

Stepper Motor Connector (wider connector / JST PH6P)

Control Board Connector (narrower connector / JST XH2.54 )

Make sure the connectors are oriented correctly with their sockets. The "key" on the connector should align with the "gap" on the sockets.

Connect all the Z Stepper motor cables, ensuring the longer 1500 mm are used for the front Z steppers and the shorter 1000 mm is used for the rear stepper motor.

The stepper motor wire colour order does not matter if the cable was supplied in the V-Core 4 kit.

Your contributions are licensed under the open source Creative Commons license.