Editing Step 40 —
24 V Circuit - Part 2

Step Type:

Drag to rearrange

Red Wire with two Fork terminals (Length: 270 mm)

Insert one end on the fourth slot (numbered 4 on the board) and tighten the screw.

Insert the other end on the middle slot of the [ +V ] section on the Power Supply and tighten the screw.

Black Wire with two Fork terminals (Length: 270 mm)

Insert one end on the third slot (numbered 3 on the board) and tighten the screw.

Insert the other end on the middle slot of the [ -V ] section on the Power Supply and tighten the screw.

After tightening the screws, pull the wire to make sure it's firmly connected. If the wire releases/moves when pulling, reinsert it and tighten the screw.

Route the wires accordingly.

Your contributions are licensed under the open source Creative Commons license.